3D Printer Build Phase II

03step2-completeWorked resumed on the Rostock Max v3 desktop 3D printer this week.  The DIY kit was donated to the KZOO Makers by www.SeeMeCNC.com and has a six step assembly plan to follow.  This week we worked on finishing Step 2, the bearings and base assembly.                                              ——->

01step3-start-assembly

Scott and Shane began work on Step 3, the top assembly.

<———-

New method for pressing bearings work well.  And Step 3, Top Assembly finished successfully.

02step3_pressing-bearings 04step3-assembly-complete

3 comments for “3D Printer Build Phase II

  1. November 30, 2016 at 2:03 pm

    That looks awesome! Can you make an update on the progress of the 3d printer you’re building?

    • Paul Moreno
      November 30, 2016 at 4:46 pm

      Hope to begin Step 4, Final assembly on December 3rd and maybe get to Step 5, installing firmware and Step 6, Calibrating too!

Leave a Reply

Your email address will not be published. Required fields are marked *

%d bloggers like this: